•  

    Click HERE to join our forum and participate in the discussions.

     

Water on passenger floor board.


James H

New member
Joined
Feb 27, 2017
Messages
73
Reaction score
0
Points
0
Location
Spokane wa
Vehicle Year
1988
Vehicle
Ford
Engine Size
2.9 V6
My credo
Hold my beer and watch this!
So, the wife is questioning how good of a deal the truck is now, I need to fix this fast and cheep. I have water on the passenger front floor board, it hasn't rained here for a few days. I pulled back the carpet, dropped the headliner trim and A pillar garnish. I though my rain gutters were leaking but I have no evidence of water or rust on the a pillar or behind the dash. The only rust on that side of the truck is on the bottom of the door. Any suggestions where to look?


Sent from my XT1080 using Tapatalk
 


JerryC

Member
Joined
Apr 10, 2014
Messages
489
Reaction score
8
Points
18
Vehicle Year
1988
Vehicle
Ford
Have you been using the air conditioning? Maybe the drain is plugged and water is finding it's way out and ends up on the floor.
 

Mer925

New member
Joined
Mar 9, 2017
Messages
7
Reaction score
0
Points
0
Age
31
The other thing which could be worse is a bad heater core, which is usually in the passanger side dash. It lets coolant flow throw when you run the heater. Cheap but takes about 9hrs as a standard fix

Sent from my SM-G920V using Tapatalk
 

JerryC

Member
Joined
Apr 10, 2014
Messages
489
Reaction score
8
Points
18
Vehicle Year
1988
Vehicle
Ford
The other thing which could be worse is a bad heater core, which is usually in the passanger side dash. It lets coolant flow throw when you run the heater. Cheap but takes about 9hrs as a standard fix

Sent from my SM-G920V using Tapatalk
I did mine in about 30 minutes. Two hoses under the hood and four small screws under the dash. The bulk of the time is draining the coolant and bringing the engine back to temp to burp the cooling system. I also replaced the hoses while I was doing it as mine were pretty old.
 

Mer925

New member
Joined
Mar 9, 2017
Messages
7
Reaction score
0
Points
0
Age
31
I did mine in about 30 minutes. Two hoses under the hood and four small screws under the dash. The bulk of the time is draining the coolant and bringing the engine back to temp to burp the cooling system. I also replaced the hoses while I was doing it as mine were pretty old.
Hah well then muuuch different than when i had done it, but this is good news! Good luck!!

Sent from my SM-G920V using Tapatalk
 

James H

New member
Joined
Feb 27, 2017
Messages
73
Reaction score
0
Points
0
Location
Spokane wa
Vehicle Year
1988
Vehicle
Ford
Engine Size
2.9 V6
My credo
Hold my beer and watch this!
Haven seen any coolant go missing, and have no charge in the a/c. It's rained the last few days, and I haven't seen any water yet, so here's for hoping my magic wand worked.. lol

Sent from my XT1080 using Tapatalk
 

Cees Klumper

New member
Joined
Nov 4, 2019
Messages
6
Reaction score
2
Points
3
Vehicle Year
1990
Vehicle
Bronco II 2WD
I had this yesterday. New-to-me '90 Bronco II, first time it had rained (heavily too) here in LA since I got it about 5 weeks ago. Drove off and on my first left hand turn heard like a river of water slosh around and soon after a large puddle of water formed on the passenger side floor. After some research I located an inspection plate/panel on the engine side of the firewall. Opened it up and sure enough the rainwater drain in the corner was completely blocked with about three handfulls of 'sludge/wet mud' (fine dust in the air here, mixed with water turns into mud). Cleaned it all out, cleared thd drain and I expect this issue will now be solved as the drain is at the lowest point in the cowl. If water can't drain it will flood the blower housing on the passenger side (which is what I figured happened when I drove and turned the car left, forcing most of the water that was sitting on the driver's side low point over to the passenger side on the right, then streaming into the cab thru the ventilation system). Now onto drying out the carpet!
 

Cees Klumper

New member
Joined
Nov 4, 2019
Messages
6
Reaction score
2
Points
3
Vehicle Year
1990
Vehicle
Bronco II 2WD
Well spoke too soon. I'm sure that cleaning out the cowl was useful but I still get a wet passenger side floor when it rains. Now I will try resealing the windshield as the next likely sculprit. Wish me luck!
 

alwaysFlOoReD

Blang - not bling
Forum Moderator
Joined
Apr 13, 2009
Messages
154
Reaction score
23
Points
18
Location
Red Deer, Canada
Vehicle Year
'91, '93, '98
Vehicle
Various
Engine Size
4.0, 4.0, 4.6
Suspension Style
4wd
Good luck.
If the detritus was under the cowl long enough there will be holes rusted thru in that area. Have you used a garden hose to try to duplicate where the water comes in?
 

Cees Klumper

New member
Joined
Nov 4, 2019
Messages
6
Reaction score
2
Points
3
Vehicle Year
1990
Vehicle
Bronco II 2WD
Thanks. After cleaning out the cowl and drain, I did poor a lot of water into the cowl to nake sure it evacuated as it is supposed to, outside underneath the car, and it does. Believe it or not, this car has zero rust due to where it lived (Palmdale in Southern California) and the cowl is also like new despite the water not draining.
I will have the windshield replaced next week due to a big crack, and I can see someone has had a go at trying to caulk the bottom of the windshield before, so my guess is it's the windshield which is the original one. We'll know next week.
 

Top